Sun Microsystems Sun Fire V215, Руководство администратора

Страница: 38 / 56

22 Sun Fire V215 and V245 Servers Administration Guide • September 2006
▼ To Update the Firmware
1. Ensure that the SC Ethernet management port is configured.
This is required to access the new flash image over the network.
2. Open a Telnet session and connect to the system controller, as in the following
example.
Substitute the IP address of your system controller.
3. Login as
admin
, using the password you defined during the configuration of the
system controller.
4. Execute
flashupdate
command.
The
flashupdate
SC command updates the system controller flash image. The
flashupdate
command requires the following information:
■
IP address of a system on the network that can access the flash image.
■
The full pathname to the flash image that the IP address specified above can
access.
■
The username and password of an account registered on the system specified by
the IP address used above.
% alternate 129.
xxx
.
xx
.
xx
Trying 129.
xxx
.
xx
.
xx
...
Connected to 129.
xxx
.
xx
.
xx
.
Escape character is’^]’.
Use is subject to license terms.
Symptom) Advanced Lights Out Manager 1.0.11 ()
Please login:
Please login: admin
Please Enter password:
password
sc>