Installing the Memory Boards on the System
Controller CPU Board
The system controller CPU board can support up to two memory boards, each
with a 512-Mbyte configuration. The first memory board is installed directly
onto the system controller CPU board. The second memory board is installed
directly on top of the first memory board.
1. Determine if one or two memory boards are being installed for this
installation.
■
If you are installing the single memory board configuration, follow
Step 2, Step 3, and Step 5 below.
■
If you are installing the double memory board configuration, follow
Step 2 through Step 5 below.
2. Using a screwdriver, set the two memory board plastic support fasteners
to the open position with the slots away from the board.
3. Align the two bottom memory board connectors (P3 and P4) above the
memory board connector sockets (J0601 and J0602), located at the center
of the system controller CPU board, and press down firmly, ensuring the
two connectors are properly seated.
Caution –
To avoid microfracture damage to the system controller
CPU board, do not apply excessive pressure on any of the
connectors.
4. For the second memory board, align the two bottom connectors (P3 and
P4) on top of the first memory board connector sockets (P1 and P2) and
press down firmly, ensuring the two connectors are properly seated in the
first memory board.
5. Using a screwdriver, set the two memory board plastic support fasteners
to the locked position by turning the fastener 180 degrees.
