Sun Microsystems SUN BLADE 150, Руководство по обслуживанию

Страница: 203 / 218

Appendix D Special Procedures D-3
2. Type a letter at the prompt to select the graphics card you want to be the default
console display.
In this example, type
a
to select the on-board M64 graphics device.
3. Set the selected device as the console device by typing:
4. Press “Control-Y”.
5. Power off the system.
See Section 5.5, “Powering Off the System” on page 5-4.
6. Connect your monitor cable to the on-board VGA connector on your system back
panel.
See
FIGURE 1-3
, in Section 1.3, “System Description” on page 1-4.
7. Power on the system.
See Section 9.2, “Powering On the System” on page 9-2.
Enter Selection, q to quit: a
/pci@1f,0/SUNW,m64B@13 has been selected.
Type ^Y ( Control-Y ) to insert it in the command line.
e.g. ok nvalias mydev ^Y
ok setenv output-device