Sun Microsystems StorageTek SG-XPCIE1FC-QF8-Z, Руководство по установке

Страница: 26 / 68

16 Sun StorageTek 8 Gb FC PCI-Express HBA Installation Guide • September 2009
Testing the Installation
This section contains the following topics:
■
“To Verify Proper Installation (SPARC Systems)” on page 16
■
“To Verify Attached Storage (SPARC Systems)” on page 19
▼
To Verify Proper Installation (SPARC Systems)
1. Use the
show-devs
command at the
ok
prompt to list the installed devices.
The HBA can be identified in the output by looking for the
SUNW,qlc@
n and
SUNW,qlc@
n
,1
node names, where n is usually a single-digit number from 0 to 9.
In this example, there is a dual port HBA (SG-SPCIE2FC-QF8-Z) installed.
TABLE 2-1
LED Status
Yellow LED Green LED Amber LED State
Off Off Off Power off
On On On Power on (before firmware
initialization)
Flash Flash Flash Power on (after firmware initialization)
Flash in sequence
*
* Flash sequence is yellow LED > green LED > amber LED, then back to yellow LED.
Flash in sequence
*
Flash in sequence
*
Firmware fault
Off Off On (for link up) or
Flash (if I/O activity) 2 Gbps link UP/ACT
Off On (for link up) or
Flash (if I/O activity) Off 4 Gbps link UP/ACT
On (for link up) or
Flash (if I/O activity) Off Off 8 Gbps link UP/ACT
Flash Off Flash Beacon
{0} ok show-devs
/ebus@c0
/pci-performance-counters@0
/pci@0
/niu@80