Sun Microsystems StorageTek 6140, Руководство пользователя

Страница: 16 / 32

Install any required patches or software for Sun StorEdge Traffic Manager software support to nodes
and enable multipathing.
For the procedure about how to install the Sun StorEdge Traffic Manager software, see “How to
Install Sun Multipathing Software” in
Sun Cluster Software Installation Guide for Solaris OS .
■
To create a logical volume, see “How to Create a Logical Volume” on page 17 .
■
To continue with Sun Cluster software installation tasks, see your Sun Cluster software
installation documentation.
▼
How to Add Storage Arrays to an Existing Cluster
Use this procedure to add a new storage array to a running cluster. To install a new storage array in a
Sun Cluster configuration that is not running, use the procedure in “How to Install Storage Arrays in
a New Cluster” on page 14 .
This procedure relies on the following assumptions:
■ (VERITAS Volume Manager Only) You have a version of VERITAS Volume Manager that
includes Array Support Library (ASL). For more information on this requirement, see
“Requirements” on page 11 .
■
You have enough host adapters to connect the nodes and the storage array to the service
processor panel.
If you need to install host adapters, see “How to Replace a Host Adapter” on page 27 . When this
procedure asks you to replace the failed host adapter, simply install the new host adapter instead.
■ You do not need to install a new node in your cluster.
If you need to add a node to your cluster, see your Sun Cluster system administration
documentation. Ensure that you install the required Solaris patches for storage array support.
Unpack, place, and level the storage array.
For instructions, see the StorageTek online documentation listed in Table P–2 .
(Optional) Install the Fibre Channel (FC) switch for the storage array if you do not have a switch
installed.
For the procedure about how to install an FC switch, see the documentation that shipped with your
FC switch hardware.
Connect the nodes to the service processor panel.
■
(SAN Configuration)
Connect the FC switches to the service processor panel.
■
(Direct-Attached Configuration) Connect each node to the service processor panel directly.
For instructions, see the StorageTek documentation listed in “Related Documentation” on page 6 .
2
See Also
Before You Begin
1
2
3
Installing Storage Arrays
Sun Cluster 3.0 - 3.1 with StorageTek Fibre Channel RAID Arrays Manual for Solaris OS • July 2006, Revision A 16