3
6. Plug the power cords into the power supplies and into a power source.
Note - Only one power connection is required for operation. Use two power connections for redundancy.
When power is applied, the SP initializes and power supply LEDs illuminate. After a few minutes, the SP login prompt
appears on the terminal device. The host is not initialized or powered on yet.
7. At the terminal device, log in to the SP as
root
with a password of
changeme
.
After a brief delay, the SP prompt is displayed (
->
). At this point, there are many commands you can perform using the
Integrated Lights Out Manager interface.
Additional SP information, such as how to change the password and how to set up the SP network parameters is
available in the online documentation set.
8. Power on the server and redirect the host output to display on the serial terminal device:
After you start the SP console, the server initialization takes approximately 20 minutes to complete.
SUNSP00144FAC732F login:
root
Password:
changeme
. . .
->
->
start /SYS
Are you sure you want to start /SYS (y/n)?
y
->
start /SP/console
Are you sure you want to start /SP/CONSOLE (y/n)?
y
Serial console started. To stop, type #.
. . .
