Operation manual of SR528Q wireless controller
- 11 -
►Press “Match” button on the display, “SAVE” shows on the screen,
►Press “Match” button on the display, “WAIT - - -“shows on the screen, (waiting for the
connection between controller and display), when display automatically returns to the
normal operation screen, it indicates the success of code match.
If “WAIT- - - “shows on the screen always, it indicates the un-success of code match,
this display’s installation place is not suitable (distance to the controller may be too far),
remount the display in a suitable place.
When 2 or above 2 displays in the system
►Press the “Match” button of display 2 for 3 seconds, “ID 01” blinks on the screen.
►Then press “ ▲ ▼” button to adjust the ID address of display, adjustable range is
01-08, and
set “ ID 02” for the second display.
►Press “Match” button on the display, “SAVE” shows on the screen, save the above
set.
►Press “Match” button on the display, “WAIT - - -“shows on the screen, (waiting for the
connection between controller and display), display automatically returns to the normal
operation screen in 6 seconds.
(According to the configured displays quantity, set the ID code and match the code for
every display one by one, and please note the ID code should not be repeated.)
After success code match for all displays,
►Press “KO” button for 3 seconds, the indicator light on the right side of controller
shines without blink (continuously shine).
►Then release “KO” button, code match finishing, controller enters the orderly
communication status.
Note
：
After the code match, you can press “▲ ▼” button to check the current
signal intensity (RSSI), if you encounter the problem like signal is too weak,
communication is unstable, lots of same frequency interfere signals occur
nearby, you can modify the communication frequency and select a ideal
frequency under the menu “COMM” (to modify the frequency must start from the
display with ID address of “ ID 01”), detailed steps see paragraph 6.7.3
(433M is an ideal communication frequency; do not change it at unnecessary
case).
