Operation manual of SR528Q wireless controller
- 10 -
3. Wireless connection
Before power switched-on, connect the sensor on the input ports; connect pump or
valve on the output ports.
Power switched-on, first of all to match the code between controller and display, then to
set up time, password and relevant parameters of system.
Note
：
the display is powered on, but before it is matched with controller, E1
shows on the screen,
it means data is not synchronized, after successful code matching, controller
just enters a orderly operation status.
3.1 Code match between controller and display
► Open the connection terminal of controller; switch
on the power of controller and display.
► Press K0 button (on the right side of controller
terminal) for three seconds until the LED indicator light
(on the right side of controller) blinks (1 second 1
blink)
►then release K0 button, wait for match of display.
Note:
When there is only a display in the system, then
set the code “ID01” for this display.
When there are several displays in the system,
then set the start code “ID01” for the first display,
the code of every display should be different and
not repeated.
►Press “Match” button of display 1 for 3 seconds, “ID
01” blinks on the screen.
►Press “▲ ▼” button, adjust the address of display,
adjustable range is 01-08, maximum 8 displays can
be matched with this controller.(Code of the first
display must be set as “ID 01”,the second display
must be set as
”ID 02”,set like this, one by one)
