Sun Gold Power Co.,Ltd
www.
sungoldpower.com
8
2. Installation Instruction
2.1 Installation notice
Before installation, please carefully read the manual and get familiar with the installation step.
➢
Take care while installing the battery. When installing the lead-acid liquid battery, it is required to wear
goggles. Any body part contacting the battery acid must be washed with clear water in time.
➢
Don
’
t place any metal object beside the battery to prevent short circuit of the battery.
➢
Acid gas may be generated during battery charge. Therefore, it is required to ensure good ventilation
around the environment.
➢
During cabinet installation, sufficient space shall be reserved around the solar charge inverter for heat
dissipation; do not install the solar charge inverter and lead-acid liquid battery in the same cabinet to avoid
the corrosion of the solar charge inverter by acid gas generated during battery operation.
➢
Only the battery with type consistent with the solar charge inverter can be charged.
➢
Loose connection points and corroded wires may cause great heat, thereby melting the insulation layer of
wires, burning the surrounding materials, or even causing fire. Therefore, all connectors must be tightened,
and the wires must be fixed with ties, so as to avoid the looseness of connectors caused by wire shaking
during mobile application.
➢
Tie conductors are selected based on no greater than 5A/mm
2
current density.
➢
The machine installed outdoors shall be protected against direct sunlight and rain.
➢
After the power switch is turned off, there is still high voltage inside the solar charge inverter. Please do
not open or touch the internal components, and carry out relevant operation after the capacitor is fully
discharged.
➢
Please do not install the solar charge inverter in a humid, greasy, flammable, explosive or dusty or other
severe environments.
➢
The polarity of the battery input end of this product shall not be reversed, otherwise the device may be
damaged easily or there may be some unpredictable dangers.
➢
AC supply input and AC output are both high voltage, so please do not touch the wires.
➢
Do not touch the fan in working to prevent injury.
➢
It is required to confirm that the solar charge inverter is the unique power supply input device for the load
device. It is forbidden to use the machine in parallel with other input AC power to avoid damage.
