Sun Fire X4600, Руководство по установке

Страница: 21 / 66

Tip –
Install the cage nuts if you plan to ship the server in the future.
From behind the rack post, put the bottom tab of the cage nut into the hole and squeeze the top
tab into the hole.
Note –
In normal installation, securing is not required. Securing provides extra stability in
special circumstances, such as shipping the server in place, that is, shipping the server mounted
in the rack and then shipping the rack.
Attach the slide rails to the rack.
Each slide rail has an attachment assembly at either end. Each assembly has two pins that fit into
the rack holes (either round and square) and a spring that holds the rack rail against the
assembly. The front part of the rail is stamped with the word “FRONT.” The rear part of the rail
is stamped with the word “REAR.”
a. Orient the slide rail with the ball bearing track at the front of the rack.
b. Extend the slide rail to the length of the rack.
c. Slide the front attachment assembly over the rack’s posts, so that the pins fit into the rack
holes. Push the assembly into the rack post until it clicks into place.
d. Insert the rear attachment assembly into the holes of the rack post.
Tip –
Press the gray plastic tabs toward the rack post to adjust the length of the slide rails.
e. Repeat the above steps with the other slide rail.
“How to Insert the Server Into the Rack” on page 21
▼
How to Insert the Server Into the Rack
The following procedure explains how to insert the server, with the mounting brackets
attached, into the slide-rail assembly on the rack.
4
Next Steps
Slide Rail Kit
21