Summit VC28S, Инструкция по эксплуатации

Страница: 6 / 24

INSTALLATION
BEFORE USING YOUR WINE CELLAR
1.
Remove all exterior and interior
packing. Clean the interior
surface with lukewarm water
using a soft cloth. The unit may
have residual odors at first, they
will disappear as the unit cools.
2.
Before connecting the Wine
Cellar to the power source, let it
stand upright for at least 2 hours.
This will reduce the possibility of
a malfunction in the cooling
system caused by handling during
transportation.
3.
The door on this appliance can be
opened from either the left or
the right side. The unit is
delivered with the door opening
on the left side. Should you wish
to open the door from the right,
follow the instructions “Reversing
the door hinge” on page 8.
4.
Install the handle on the door if
necessary.
INSTALLATION OF YOUR WINE CELLAR
1.
This appliance is only designed to
be built-in (integrated).
Warning : Do not store or install
the appliance outdoors.
2.
Place your appliance on a surface
that is strong enough to support
it when fully loaded.
3.
For built-in installation, it is a
must to keep 5mm (0.2”) of
space on each side and at the top
and 50mm (2”) at the rear to
ensure proper service access and
ventilation. Take care that the
bottom of the appliance is not
blocked in any way so that air
circulation can occur freely.
4.
Locate the unit away from direct
sunlight and sources of heat
(stove, heater, radiator, etc.).
Direct sunlight may affect the
finish and heat sources may
increase electrical consumption.
Extremely cold ambient
temperatures may also cause the
unit not to perform properly.
5.
Avoid locating the unit in damp
areas.
6.
Plug the unit into an exclusive,
easily accessible plug socket. Any
questions concerning power
and/or grounding should be
directed towards a qualified
electrician or an authorized
products service center.
7.
The appliance must be installed
to all electrical, plumbing, water
and drain connections in
accordance with state and local
codes.
8.
IMPORTANT:
High Humidity Climate
During periods of high humidity,
some condensation may appear
on the outside surface of the
glass door. This condensation will
disappear when humidity levels
drop. For prevention, it is
advisable to install the appliance
with sufficient ventilation in a dry
and/or an air-conditioned place.
Note: Make sure that the socket
and ON/OFF switch are easily
accessible after the appliance
has been installed
.
5