Summit TTM13027BKSW, Руководство пользователя

Страница: 17 / 32

17
ALIGNMENTS AND ADJUSTMENTS, Continued
Ovens with Pilotless Electric Spark Ignition: Free-Standing Ranges
Ranges equipped with the spark ignition system will have an oven pilot ignitor that has a
"flame sensing" feature that automatically stops the sparking once the oven pilot gas is
ignited. Turning the oven control dial on will activate an electronic module and send
pulses (sparks) to all electrodes (including the top burner electrodes) at a rate of
approximately 1 1/2 pulses (sparks) per second.
MOISTURE:
Moisture can have the same effect on the oven ignitor as the pilot flame. If
sparking does not occur when the oven thermostat knob is turned on during the initial
attempt to use the oven or after several days of non-use, it
COULD BE the result of
moisture build-up in the ceramic sleeve of the oven electrode. This may happen in areas
with high humidity or if food having high water content is cooked. This moisture can be
driven out of the ignitor by lighting the pilot and operating the oven for a few minutes.
Follow the instructions below for lighting the pilot.
NEVER LEAVE THE CONTROL KNOBS IN ANY POSITION OTHER THAN
"OFF" IF THE IGNITORS OR BURNERS AREN'T WORKING PROPERLY.
• With the oven control OFF open the broiler door and position yourself so you can see
the oven pilot at the back of the oven burner.
• Next turn any top burner knob to the "LITE" position while watching the oven pilot. Turn
the oven control on. If the oven pilot doesn't ignite within five seconds immediately turn
the oven control off. If the oven pilot does ignite, the oven
burner
should ignite within
60 seconds. If not, immediately turn the oven control off and call a serviceman.
If the oven is working, to determine if moisture was the problem wait a few minutes and
attempt to light the oven by turning the oven control dial on. If sparking occurs at the oven
electrode to ignite the oven pilot and within sixty seconds ignites the oven burner then
moisture build-up was the problem. If the oven burner doesn't ignite within 60 seconds
turn the oven control off and call the serviceman.
• If for some reason there isn't sparking, indicating the module isn't working, or there is a power
failure and oven cooking is necessary you may manually light the oven.
Make certain the oven is cool when manually lighting oven pilot.
• Open broiler door . Oven pilot is located on the left side of the oven burner at the back
of the burner.
• Hold a lighted match and reach through the broiler compartment to the oven pilot.
•
While holding the lighted match
near the tip of the pilot assembly, turn the oven control
dial to an ON position. Immediately remove your hand from the broiler compartment
after the pilot gas ignites. From 20 to 60 seconds after the pilot ignites, gas will flow to
the oven burner and the burner will ignite.
• Close the broiler door .
•
Set desired temperature
.
•
When cooking is finished
, turn the Oven Temperature Control to OFF. This will shut
off all gas to the oven.
CAUTION
!