background image

 

 

CARE AND MAINTENANCE 

 

Cleaning Your Appliance 

1.  Turn off the power, unplug the appliance, and remove all items including shelves and racks.   

2.  Wash the inside surfaces with a warm water and baking soda solution. The solution should consist 

of about 2 tablespoons of baking soda to a quart of water. 

3.  Wash the shelves with a mild detergent solution. 

4.  Wring  excess  water  out  of  the  sponge  or  cloth  when  cleaning  the  area  of  the  controls  or  any 

electrical parts. 

5.  Wash the exterior of the cooler with a warm solution of mild liquid detergent. Rinse well and wipe 

dry with a clean soft cloth. 

6.  For stainless steel surfaces, routine cleaning can be accomplished by using warm water and a cloth. 

Dry with a towel or cloth to prevent water spots. Wipe in the directions of the brush lines. For 

cleaning that needs more power, you can use a mild detergent in warm water. Make sure to rinse 

the surface thoroughly to prevent staining and spotting. Towel dry.   

Defrosting 

Defrosting of the inside the appliance occurs automatically during operation. Approximately every 8 

hours, the compressor will stop running for about 30 minutes. During defrosting the temperature will be 

higher than you set.    The defrost water is collected by the evaporating tray above the compressor and 

evaporates automatically. 

Power Failure

 

Most power failures are corrected within a few hours and should not affect the temperature of your 

appliance if you minimize the number of times the door is opened. If your power is going to be off for a 

longer period of time, you need to take the proper steps to protect your contents. 

Vacation Time 

Leave the appliance operating during vacations of less than three weeks. If you turn off the appliance 

for extended periods, leave the door slightly ajar to prevent odor building up inside. 

Transporting Your Appliance 

If you need to move your appliance once the box has been discarded: 

1. 

Securely tape down all loose items (shelves) inside your appliance. 

2. 

Turn the adjustable legs up to the base to avoid damage. 

3. 

Tape the door shut. 

4. 

Be sure the appliance stays secure in the upright position during transportation. Also protect the 

outside of the appliance with a blanket or similar item. 

Energy Saving Tip 

The appliance should be located in the coolest area of the room, away from heat-producing appliances 

and out of direct sunlight. 

 
 

Содержание SWC3066B









Отзывы: