Summit SCR611GLOS, Инструкция по эксплуатации

Страница: 8 / 16

8
6. Relocate the door to the designated position. Then screw the bottom hinge assembly on the left
designated position and tighten itafter the door is leveled. (Fig. 1)
7. Remove the handle from the left side of the door and install it on the right side. ( See next section.)
INSTALLING THE STAINLESS STEEL HANDLE
This appliance includes a stainless steel handle that is not required
to operate the unit. To install the handle, follow the instructions
below:
1. Remove the door gasket (2) on the side you wish to install the
handle - you can see two designated holes for handle
installation.
2. Install the handle (4) tightly as shown above with two screws (1)
and flat washers (3) provided.
3. Replace the door gasket.
OPERATING YOUR APPLIANCE
It is recommended that you install the appliance in a place where the ambient temperature is between72º
and 78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The range of 36º-43ºF (2º-6ºC) may not be
reached.
CONTROL PANEL
ON/OFF Power
To turn the appliance off, pressand hold the key for 5 seconds until the temperature display goes
off. To turn the appliance on, pressand hold the key for 1 second until the temperature display
lights up.
NOTE: Pressing thePOWERkey once can switch off the audible alarm when the alarm is on.
UP
Used to increase (warm) the set temperature by 1°C/1ºF.
DOWN
Used to decrease (cool) the set temperature by 1°C/1ºF.
Interior Light
The interior light makes it easy to view your items. Touching theLIGHTsymbol toggles between 2
modes of operation forthe internal lights: functional (default) mode and showcasemode. If you are