7-DAY TIMER
INSTRUCTIONS
© 2017 Security Brands Inc. All rights reserved.
I-ST-EN Rev. B
BUTTONS/INDICATORS
CLOCK
: to adjust day and time; must be pressed and
held to allow use of the day and time buttons
TIMER
: to set up and review programmed events
DAY
: to adjust day of week
HOUR
: to adjust hour
MIN
: to adjust minutes
MANUAL
: to select between
ON
/
AUTO
/
OFF
modes
(active mode indicated by bar on LCD)
Modes:
ON
: relay is active
AUTO
: timer will follow user-specified programs
OFF
: relay inactive; no programs will be followed
ON
: relay indicator (LED on when relay is active and
off when inactive)
P : resets timer settings
EXITING PROGRAMMING MODE
Once all events are programmed, press
CLOCK
to
exit programming mode.
ACTIVATING TIMER FOR AUTOMATIC USE
Press
MANUAL
button until indicator bar on LCD
screen is displayed above
AUTO
.
REVIEW PROGRAMMED EVENTS
Press
TIMER
button to see the first event
programmed. Repeat to review each event.
NOTE: If an ON time is set, a corresponding OFF
time must also be set.
NOTE: Timer will exit programming mode
automatically after 20 seconds of inactivity.
WIRE CONNECTIONS
NOTE:
Use 1/4″ female spade connectors for your
wire connections.
1 = Power Po (S-T12 = 12 VDC,
S-T24 = 24 VAC/DC, S-T110 = 110 VAC hot)
2 = Power Negative - (S-T12 = 12 VDC,
S-T24 = 24 VAC/DC, S-T110 = 110 VAC neutral)
3 = Timer Relay NC (Normally Closed)
4 = Timer Relay NO (Normally Open)
5 = Timer Relay COM (Common)
Refer to
Figure 4
.
Figure 4: Wire Connections (rear of unit)
Figure 3: Front Panel
TIMER OPERATION
SETTING TIME AND DATE
Press and hold
CLOCK
, then use the
DAY
,
HOUR
,
and
MIN
buttons to set time and date.
PROGRAMMING EVENT 1
1. Press
TIMER
. 1
ON
--:-- will appear on LCD screen
unless a time is already stored in memory.
2. Press
DAY
until desired daily program schedule
is displayed on LCD screen (See
Figure 1
).
3. Press
HOUR
and
MIN
to set desired ON time.
4. Press
TIMER
button again. 1
OFF
--:-- will appear
on LCD Screen unless a time is already stored in
memory.
5. Set desired OFF time as before.
PROGRAMMING EVENTS 2–17
Repeat steps listed for programming event 1.
