background image

 
 
 
 
 

 

This unit is not designed to operate in enclosed spaces. When placing your unit, 

make sure you allow at least 4” of clearance on all sides.

 

 

Use two or more people to move and install the freezer.  Failure to do so can result in 

back or other injury. 

 

To ensure proper ventilation for your  freezer, the front of the unit must be completely 

unobstructed.  Choose a well-ventilated area with temperatures above 60°F (16°C) and 

below 90°F (32°C). This unit must be installed in an area protected from the elements, 

such as wind, rain, water spray or drips, and away from direct sunlight. 

 

The  freezer should not be located next to ovens, grills or other sources of high heat. 

 

The  freezer must be installed with its electrical connection in accordance with state and 

local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in 

accordance with the National Electrical Code and local codes and ordinances is required. 

 

Do not kink, pinch or coil the power supply cord of the  freezer.  Keep cord away from the 

compressor at the back of the appliance; heat from the compressor could damage the 

insulation of the cord and cause electrical leakage. 

 

The fuse (or circuit breaker) size should be 15 amperes. 

 

It is important for the  freezer to be leveled in order to work properly. You may need to 

make several adjustments to level it.  

 

I

n order to ensure normal operation of the 

freezer

, after moving it a considerable 

distance, you must wait for ½ to 1 hour before turning the unit on. 

 

After an electrical failure, wait at least 5 minutes before turning on the 

freezer

 again 

or the compressor may be damaged. 

 

This appliance is not intended for use by persons (including children) with reduced 

physical, sensory or mental capabilities, or lack of experience and knowledge, unless 

they have been given supervision or instruction concerning use of the appliance by a 

person responsible for their safety. 

 

IMPORTANT: Do not use mechanical devices or other means to accelerate the 

defrosting process, other than those recommended by the manufacturer. 

 

IMPORTANT: Do not damage the refrigerant circuit. 

 

IMPORTANT: Do not use electrical appliances inside the food storage compartment of 

the appliance, unless they are of the type recommended by the manufacturer.   

 

Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners 

may damage or discolor the interior. 

 

Do not use this apparatus for other than its intended purpose. 

 

SAVE THESE INSTRUCTIONS 

 

3

Содержание FS22L













Отзывы: