11
and will decrease by one degree each time you touch the
DOWN
symbol.
The range of set temperatures is from 36°F to 43°F.
To view the set temperature at any time, touch the
UP
or
DOWN
symbol. The set temperature will
temporarily flash in the display window for 5 seconds. Then the display shows the current inner
temperature again.
Interior Light
The unit is equipped with interior LED lights which will be turned ON when the door is opened. LED
lights are designed for extremely long life. They are not user serviceable. To change them, please
contact the service department.
NOTE:
Please use only the original LED light fittings provided by the manufacturer.
Sabbath Mode
Sabbath mode is available for the observance of certain religious holidays. This mode turns off
the displays, interior light, and audible alarms and prevents them from turning on again. Normal
cooling operations will still take place.
To initiate Sabbath mode, touch the
POWER
and
ºC/F
keys at the same time and hold for at
least 5 seconds. The indicator light (the dot at the bottom right of the display) will flash four times
and the display will go out to confirm the Sabbath mode is ON.
Sabbath mode can be canceled by repeating the above process. The Sabbath Mode will
automatically turn off after 48 hours.
Temperature Memory Function
In the event of a power interruption
(power surge, breaker switch, etc.)
, the unit can remember the
previous temperature settings, and when power is recovered, the cabinet temperature will return to
the same set temperature as before the power went off.
Defrosting
Under normal operating conditions, the unit requires no manual defrosting.
The evaporator behind the rear wall of the unit defrosts automatically. The condensate collects in
the
drainage channel behind the rear wall of the unit and flows through the drainage hole into the
drip tray by the compressor where it evaporates.
However, frost may accumulate on the evaporator if the unit is repeatedly opened in high heat or
high humidity locations. If this frost pattern does not clear within 24 hours, your unit will require
manual defrosting.
NOTE:
If the unit is unplugged or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
When you use the unit for the first time or restart the unit after it has been shut off for a long
time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.
