Summit CP36BK, Инструкция по эксплуатации

Страница: 5 / 16

INSTALLATION INSTRUCTIONS
Before Using Your Appliance
1. Remove the exterior and interior packing. To remove any remaining tape or
glue, rub the area briskly with your thumb. Tape or glue residue can also be
easily removed by rubbing a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluid or abrasive
cleaners to remove tape or glue. These products can damage the surface of
your refrigerator.
2. When moving the appliance, do not tilt it more than 45° from the upright position.
3. Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
4. Clean the interior surfaces with lukewarm water using a soft cloth.
Installing Your Appliance
WARNING: Keep flammable materials and vapors such as gasoline away from
the refrigerator.

Place your appliance on a floor that is strong enough to support it when fully
loaded. To level your appliance, adjust the leg at the front of the appliance.

To ensure proper ventilation for your refrigerator, leave 8" of space on each
side, 4" between the back of the unit and the wall, and 12" above the unit.

If you are installing the refrigerator next to a fixed wall, leave sufficient space
on the hinge side to allow for the door to swing open.

Locate the appliance away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight can affect the refrigerator's coating and
heat sources can increase electrical consumption. Extremely cold ambient
temperatures may also cause the appliance to perform improperly.

Avoid locating the appliance in moist areas. Too much moisture in the air will
cause frost to form quickly on the evaporator, requiring more frequent
defrosting of the appliance.
Electrical Connection

Warning

Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, have it replaced by an authorized
service technician.

This appliance should be properly grounded for your safety. The power cord
of this appliance is equipped with a three-prong plug which mates with stan-
dard three-prong wall outlets to minimize the possibility of electrical shock.
4