8
Installation of the Handle
To install the handle, please follow these instructions:
1. Carefully pull the door gasket (seal) away from the door in the area where the handle will be
attached.
2. Place the handle over the screw holes on the outside of the door. The screws will attach through
the back of the drawer front.
3. Secure the handle with the screws that have been provided.
4. Press the door gasket back into its groove.
Panel Ready Installation
The appliance is designed to be panel ready. To install a custom panel on the front of the drawers of
your appliance, follow the steps below:
1. Open the drawer and remove the screws from the back of the drawer, holding the handle in
place.
2. Remove the four screws from the bottom of the drawer.
3. Prepare your panel with installation holes and holes for the bottom mounting brackets (20 x
6mm), then secure the mounting brackets to the panel with screws. Be sure to add handle holes
to the panel
NOTE:
The measurements listed in the graphic below are in millimeters.
