5.
Place the Seat Tube (
item G
) onto the Foot Platform inside of the tubing as shown in
figure 5
. Insert (1) 65mm bolt and lock
nut, per side, to secure.
6.
Pivot the Seat Tube up. Place the Seat Tube to the BACKSIDE of the V-Plate Frame (
item F
) as shown in
figure 6
. Insert (1)
65mm bolt with lock nut on each side to secure.
7.
Place the Seat Base (
item H
) between the two Seat Frame Assemblies. Insert (1) 65mm bolt with a Nylon Washer - Wide
between the Seat Brace and Seat Frame. Use a locknut to secure. Repeat for the other side. Secure tightly.
See figure 7 and 8.
Note: The Seat Base has mounting holes on the non-bent end of the seat tubes.
8.
Place the Seat Back (
item I
) between the Seat Frame Assemblies. Insert (1) 65mm bolt with a Nylon Washer - Wide between
the Seat Brace and Seat Frame. Use a locknut to secure. Repeat for the other side. Secure tightly.
See figure 9.
Note: The Seat Back has mounting holes on the bent end of the seat tubes.
9.
Place the Gun Rest (
item J
) onto the outside of the Seat Frame Assembly. Insert (1) 70mm bolt through Gun Rest in the hole
closest to the end of the Gun Rest Tube. Use a Nylon Washer - Narrow between the Gun Rest and the Seat Frame.
See figure 10.
Part Stack: Gun Rest, Nylon Washer - Narrow, Seat Frame, V-Plate Frame.
Secure with a locknut. Repeat for the other side.
10.
Insert (1) 50mm All Thread Bolt into the second hole on the Gun Rest (
item J
) and secure with a locknut as shown in
figure 10.
Note: This bolt is used as a Gun Rest stop.
PG 6
www.summitstands.com
5
G
G
E
6
G
F
SEAT ASSEMBLY
8
H
9
MOUNTING
HOLE ON BENT
END
I
10
HOLE CLOSEST
TO THE END
J
GUN REST - STOP
BOLT - ALL THREAD
7
H
MOUNTING
HOLE ON NON-
BENT END
