ATTACHMENT STRAPS - ALL MODELS
SEAT - 82084 PEAK
PG 7
1.
Position the stand so that you have access to the
seat support as shown in
figure 11
.
2.
Lay the foam seat on the frame as shown in
figure 12
.
3.
Bring one of the straps up from the inside and
wrap it around the lower support bar. See
figure
13
.
4.
Turn the three bar slide sideways and push it
through the D ring as shown in
figure 14
.
5.
Your finished buckle should look like
figure 15
.
Repeat
Steps 1 - 4
for the remaining buckles.
11
12
13
14
15
1.
Using
figure 16
to the right, thread the free end
of the strap with the double J-Hook through the
buckle as shown.
NOTE: Double J-Hook MUST be
pointed out away from the tree when in use.
See
figure 16
.
2.
A properly threaded strap should tighten when
the free end is pulled.
Discontinue use immediately if the hanging strap
does not remain tight against the tree.
3.
Attach the bottom ratchet strap to the stand.
To connect the straps to the stand, wrap the straps
around the frame and bring the ratchet or the free
end back through the loop to create a cinch knot
as shown in
figure 17
.
NOTE: Straps must attach
to the vertical Seat Upright bar, BELOW the
horizontal bar as shown.
DOUBLE J-HOOK
DOUBLE J-HOOK
HANGING TAB
HANGING TAB
TREE
Looking Down
BUCKLE
TREESTAND
FREE END
WARNING
!
ALWAYS
ensure the strap remains tight once pulled
tight. If the strap loosens
DO NOT
use the treestand.
Inspect the strap to ensure it was threaded correctly
before proceeding.
16
17
BOTTOM SUPPORT
STRAP
