Summit Commercial BIM-44 G, Руководство пользователя

Страница: 28 / 60

27
TROUBLESHOOTING
Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION section of this
manual first. If the problem persists, check the Troubleshooting Guide on the following
pages. Some of the problems mentioned in the Guide can be solved easily without a
service call.
Troubleshooting Guide
Problem Possible Cause Probable Correction
The machine
doesn’t operate.
The ice maker is unplugged. Plug the ice maker in.
The fuse is blown.
Replace fuse. If it happens again, call for
service to check for a short circuit in the unit.
The ice maker power button
is set at OFF.
Switch the ice maker power button to ON.
The ice storage bin is full of
ice.
Remove some ice cubes. Be sure the ice-full
probe is free of ice.
The water doesn't
feed in after the
machine starts.
The water supply tap is
turned off.
Turn on the water supply tap.
The water supply pipe is not
properly connected.
Reconnect the water supply pipe.
Machine makes ice,
but bin does not fill
up with ice.
The condenser may be dirty. Clean the condenser.
The air flow to the ice maker
may be obstructed.
Check the installation.
The ambient temperature and
water temperature are high,
or unit is near some heat
source.
Check the installation.
Water is leaking out
of the unit.
Some water falls to the floor
when you open the door to
remove ice from storage bin.
Normal condensation on the door or some
water together with ice. Take care when you
take out ice.
Water supply connection is
leaking.
Tighten fitting. See Connecting the water
line .
Drain pipe higher than drain
outlet.
Lower drain pipe.