12
Lighting Instructions
Caution:
Never operate the grill unattended. Do not operate the rotisserie or Sear Zone burner with the
hood closed.
Prior to using your grill, make sure all of the following is correctly completed:
Verify that the burner tube is free of insects and insect nests, webs, etc.
Verify installation of the proper gas type and regulator settings.
Verify that the proper gas connection is complete.
Minimum clearances are maintained.
All packaging has been removed.
All parts and components are properly in place.
That an installer supplied manual gas shut-off valve is fully accessible.
Clean and inspect LP hose for cuts, wear, abrasion, or leaks. Replace if necessary with a suitable UL,
ETL or CSA Listed part with internally threaded connector.
LIGHTING YOUR GRILL
Become familiar with the safety instructions at the front of this manual. Do not smoke while lighting
the grill or checking the gas supply connections.
Make sure that all gas connections are securely tightened and have been leak tested with a soapy
water solution - never with a flame!
READ THESE GRILL AND ROTISSERIE LIGHTING INSTRUCTIONS BEFORE LIGHTING
- KEEP THE GRILL HOOD OPEN DURING THE LIGHTING PROCESS. MAKE SURE ALL THE
BURNER KNOBS ARE TURNED TO THE "OFF" POSITION.
- PUSH IN AND TURN THE KNOB TO THE HIGHEST POSITION SETTING.
- IF THE BURNER DOES NOT IGNITE WITHIN 5 SECONDS, TURN THE BURNER TO THE "OFF"
POSITION AND WAIT 5 MINUTES. REPEAT THE ABOVE STEPS.
TO SAFELY SHUT DOWN THE GRILL, TURN ALL BURNERS TO THE "OFF" POSITION. FOR LP
GAS MODELS, IN ADDITION IO TURNING THE BURNERS OFF, TURN THE VALVE ON THE GAS
CYLINDER TO THE "OFF" POSITION WHEN NOT IN USE.
If the burner still does not light, refer to the manual and make sure the unit is set up properly before
calling for service.
Warranty work is not provided for customer education on the operation of the unit.
TROUBLESHOOTING:
If your grill fails to properly light, wait five minutes and repeat the above procedures.
