Summer Garden Buildings Hipped Summerhouse 270, Руководство по сборке

Страница: 3 / 8

3. Door header panel Summer Garden Buildings – Hipped Summerhouse 270
Interlock the 2 door header panels and secure together using 8 x 63mm screws as shown. Position the header panel on top of the font panels. Drill 2 x 8mm holes in
each front panel top frame then fix the header panel to the front panels using 2 x 50mm screws and washers per front panel. do not over tighten these screws at this
stage. Position the 2 shiplap door header boards as shown, ensuring that the tongue of the front panel cladding is fitted into the groove of the door header boards.
Secure each header board in place using 4 x 25mm screws, when securing ensure the 2 boards are level and meet in the middle of the building.
3mm
Drill
Drill 3mm pilot
holes for each of
these screws.
63mm
Drill 3mm pilot
holes for each of
Important Note:
3mm
these screws.
Drill 8mm pilot Drill
holes in the top
frame of the front
8mm
panels only.
Drill
25mm
Washer
Important Note:
Do not over tighten these
screws at this stage. Once the
doors are fitted use to adjust
50mm
the distance between the
front panels to allow the
doors to shut properly then
fully tighten the screws to lock
the position.
4 uring the walls to the floor
25mm
Ensure the walls are sitting square on the floor and front panels is 1730mm.Sec nels down using 2 x 63mm screws per panel,
screwing through the panel framing and floor
and floor into the floor joists.
63mm
63mm
1730mm
5. Roof panels
into the floor joists. For each front panel use 2 x 63m
Side panel
63mm
Floor joists
Back panel
Floor
le into each corner, through the panel frames
Front panels
63mm 63mm
Panel frame
As shown below construct a side roof section using a right and a left triangular roof panel. screw together using 2 x 50mm screws. Assemble a second side roof section in
the same way. Create the front roof section using a right and left triangular roof panel and a rectangular roof panel as shown below using 4 x 50mm screws. Assemble a
second section in the same way for the back.
Side roof sections. Front and back roof sections.
Create 2 identical side Create 2 identical sections 1 for
sections, 1 for the left the front and 1 for the back of
and the other for the the summerhouse.
right side of the
summerhouse.
50mm
50mm
For sales advice before you buy phone Summer Garden Buildings free 7 days a week on 0800 9777828