Snapshots: Taking Snapshots Using Hardware Trigger
46
SMX-10Mxx Series USB2.0 Camera User Guide
2
Check the
Loop
box in the
Snapshot
section of the main window.
3
Click the
Snapshot
button. Snapshots will continuously appear in the
Snapshot
window.
4
To stop taking snapshots, press
Cancel
.
Note:
It is strongly recommended not to change any of the camera’s settings when running the
Snapshot Loop
mode.
This may interrupt the camera operation.
Taking Snapshots Using Hardware Trigger
To take a snapshot using a hardware trigger:
1
Connect an external device (equipment).
2
Turn the video mode off (press
Shift+F5
or the
Stop Video
button in the toolbar).
3
Set exposure, gain, viewport, etc.
4
Set
Timeout
(seconds to wait for external triggering pulse).
5
Check the
External Trigger
box.
6
Click the
Snapshot
button.
Figure 6-2
Taking a snapshot using the hardware trigger
7
Apply triggering pulse (see
“External Trigger Connector Pinout” on page 47
).
8
As a result, the
Snapshot
window will open if the camera has detected the external
triggering pulse.
9
If it failed to detect the external triggering pulse, the
Snapshot
window will not open
and a timeout message will be displayed in the application status bar.
Figure 6-3
Timeout message in the application status bar
Содержание SMX-10M Series
