PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
OPERATION MANUAL
Air Sprayable Seam Sealer Applicator
Nozzle Purging
A characteristic of the ir Sprayable Sealant and the Sprayable Seam Sealer Applicator Gun is that some
sealant continues to flow out of the nozzle after the trigger is released. In order to control this flow of
sealant, a purging method to remove the excess sealant in the nozzle was developed. The correct purging
method is as follows:
Do not change the plunger or air atomization pressure setting that were used during the application of the
sealant.
Squeeze the Air Sprayable Seam Sealer Applicator Gun trigger to approximately of the full trigger action,
using. If have not, it will be leak for throttle valve. This will clear the spray nozzle of sealant. Two fast, short
strokes. Only air should came out of the nozzle. This will clear the outer nozzle of sealant.
Cautions for Use
Pressure Valve Settings
Technicians will need to adjust pressure settings and vary nozzle tip distances from the surface in order to
achieve the desired appearance of a bead, sprayed seam and coating. The air line pressure to the Air
Sprayable Seam Sealer Applicator Gun should be controlled via a pressure regulator and operated in the
range of 50-90 PSI.
(DO NOT EXCEED 90 PSI)
When the applicator gun pressure and the distance from the surface are adjusted appropriately,
no over-spray is observed. If over-spray is experienced, check the air pressure to the gun. The following
pressure valve setting are listed as general guidelines for producing the desired patterns.
BEADS
SPRAYED SEAM
COATING
Adjust red valve to: 10° - 15°
Adjust blue valve to:
Narrow Bead 15° - 30°
Wide Bead 35° - 55°
Heavy Bead 60° - 90°
*
Spray at a distance of 0 - 1 inches from the
surface to minimize over-spray.
Adjust red valve to: 45° - 60°
Adjust blue valve to 35° - 55°
*
Spray at a distance of 6 - 10 inches from
the surface to minimize over-spray.
Adjust red valve to: 20° - 35°
Adjust blue valve to 60° - 90°
*
Spray at a distance of 6 - 10 inches from the
surface to minimize over-spray.
3 / 6
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
CAUTION
During the purging cycle, the plunger pressure (BLUE VALVE) must be SET at ZERO
and the air atomization pressure (RED VALVE) must be set LOWER then 4. If pressure
is set higher than 4, the procedure will create back pressure and cause the plunger in
the cartridge to reverse discharge sealant into the gun barrel. It will also cause
applicator gun failure and void the manufacturer's warranty.
PNEUMATIG
