7
Dismantling
•
Dismantle socket head screw (3/1) with lock washers (3/3) and propeller washer (3/2).
•
Withdraw the propeller (3/4) from the propeller shaft. Remove key (3/5) from the end of the shaft.
Assembly
•
Clean carefully shaft and boss. the key to the shaft end.
ATTENTION
Do not use any products containing molybdenum disulphide!
•
Bring the groove of the propeller hub into line with the shaft key and push the propeller carefully to a stop.
•
Fit the securing washer and the propeller washer (where applicable) to the socket head screw. Ensure the correct fitting position of the
securing washers.
•
Screw in the socket head screw and tighten it to the specified tightening torque.
5.3
Tightening torque
See chapter 8.2 of the Installation and Operating Instructions 15972513-EU.
5.4
Installation example XRW 330
We recommend that the closed bracket be used for this type of installation
1
2
3
5
4
6
7
1581-00
Legend
1 Hoist with winch and rope
2 Upper bracket with locking plate
3 Closed bracket
4 Bottom plate
5 Safety stop clamp
6 Swivelling square guide tube
7 Cable clamp with cable hook
Figure 4 Installation example XRW 330
5.5
Brackets XRW/XSB-KA
See chapter 8.5 of the Installation and Operating Instructions 15972513-EU.
5.6
Guide tube lengths (square tube) XRW/XSB-KA
See chapter 8.6 of the Installation and Operating Instructions 15972513-EU. XRW 330
=
XRW 400, □ 100 x 100.
5.7
Electrical connection
See chapter 9 of the Installation and Operating Instructions 15972513-EU.
See figure 22/23.
6 - 7
Commissioning; Maintenance
See chapter 12 - 13 of the Installation and Operating Instructions 15972513-EU.
EN 6006544-A