H.
F.
I.
B. A.
K.
2
THE TABLE TOP
Parts Needed: A (2), B, D (6), E (24), H, M (2), N (4)
Page 5
www.SullivansUSA.net
INSTRUCTIONS
2A
Lay the 2 Side Boards (A) with the Middle Board (B) between them on a clean, protected surface with the pre-drilled
holes facing up. Line up the holes on all the boards.
3
ATTACHING THE BASE & TABLE TOP
Parts Needed: F (6), H, O (2), P (6)
3A
Carefully flip the base upside down. See FIGURE 2. Line up the base with the pre-drilled holes on the Middle Board
(B) and secure the top two and bottom two holes with 4 Allen Bolts (F). Tighten securely but do not overtighten.
2B
Align the 6 Hinges (D) over the predrilled holes on the boards. Be sure that the “bump” is facing up. Secure all of the
Hinges (D) to the Side Boards (A) and Middle Board (B) using the Allen Key (H) and 24 Allen Bolts (E). Tighten securely
but do not overtighten.
Align the 2 Leg Clamps (M) over the pre-drilled holes in the center of the Side Boards (A). Screw the Leg Clamps (M)
in using a Phillips Screwdriver (not included) and 4 Phillips Screws (N). The clamps should face inward toward the
Middle Board (B). Leave the Table Top flat when complete.
A.
A.
B.
2A
H.
E.
D.
N.
M.
2B
3
ATTACHING THE BASE & TABLE TOP (CONTINUED)
FIGURE 2
3A
Rev. 11-21-18