INSTRUCTIONS
K.
C1.
C2.
1
THE BASE
Parts Needed: C1 (4), C2 (2), G (4), H, I, J, K (2), L (2), O (2), P (8)
2
THE TABLE TOP
1A
C1.
L.
1B
1A
Screw 1 Caster (C1) and 1 Locking Caster (C2) into the
bolt holes on the bottom of each Side Beam (K).
1B
Screw 1 Caster (C1) into the bolt holes on the bottom
of each Wing Support (L).
1C
Take the Top Beam (I) and turn the side with 6 holes
down, toward the casters. Use 2 Allen Bolts (G) with
the Allen Key (H) to attach the Top Beam (I) to the Side
Beams (K). Do not overtighten. Be sure that the Locking Casters (C2) are on opposite sides of each other.
1D
Insert the top peg of 1 Wing Support (L) into the third
hole on the bottom of the Top Beam (I). Insert the other
Wing Support (L) into the fourth hole, making sure that
the Wing Supports do
not
face the same way. Take the
Bottom Beam (J) and place the bottom pegs of the Wing
Supports (L) inside the holes on the top of the Bottom
Beam (J). Secure the Bottom Beam (J) to the Side Beams
(K) using the Allen Key (H) with 2 Allen Bolts (G).
To ensure the correct position of the Wing Supports,
face one of the Side Beams (K). The peg on the Wing
Support (L) to your right should be inserted into the
innermost hole at the side closest to you and swing
out away from the table, towards you. See FIGURE 1.
1E
Use a Phillips Screwdriver (not included) and 4 Self-Tapping
Phillips Screws (P) to attach a Corner Bracket (O1) to the
Bottom Beam (J) and Side Beam (K). Repeat for other side.
Page 4
www.SullivansUSA.net
G.
L.
I.
K.
G.
K.
K.
C1.
C1.
C2.
C2.
I.
H.
1C
L.
L.
K.
K.
J.
P.
O1.
J.
1D
1E
G.
FIGURE 1
Rev. 11-21-18