Sullivan-Palatek 125UD Скачать руководство пользователя страница 19

Страница: 19 / 64

__________________________________SULLIVAN-PALATEK

SECTION 5

OPERATION

5.1 INTRODUCTION

Read this entire Operator’s Manual to be familiar with the SULLIVAN-PALATEK Plant Air Compressor,
giving special attention to the SECTION 1 - SAFETY.

5.2 INITIAL

START

1. Open main disconnected to be sure there is no power to the compressor.
2. Review all the steps covered in SECTION 4 – INSTALLATION to be sure all instructions have been

complied with.

3.  Inspect the compressor for any visible signs of damage that may have occurred during installation.
4.  Check the compressor oil level. Check that the oil fill cap is tight.
5.  Make sure the starter door is closed and latched.

WARNING: Do not power up the compressor starter with the starter door open!

6. Close the main disconnect; the compressor starter will now have power. The microprocessor will

boot, connect to the drive, then the display will illuminate and indicate line pressure.

WARNING: Reverse rotation will cause damage that is not covered by warranty. Rotation must be
checked whenever the motor has been disconnected.

7. Start the compressor by pushing the green “run” button.
8. With the service valve open, allow machine to pump up to normal operating pressures and observe

operation of automatic controls. Check for any possible leaks.

9. Check operation throughout the range of pressures, observing operating temperatures.
10. Push red “stop” button and check compressor oil level after it has been allowed to settle for a few

minutes. If it is necessary to add oil, be sure to open the main power disconnect, lock it out, and
relieve all oil separation tank pressure prior to removing fill cap to top off the tank.

11. If the control or unload pressures are incorrect, adjust the pressures in the microprocessor. Do NOT

raise the pressure without consulting the factory!

5.3 MICRO-PROCESSOR

PROGRAMMING; GENERAL INSTRUCTIONS

The operational menus normally addressed are P01 (operations), P02 (fault history), and P04
(maintenance setting). Access codes which are required to change settings are:

0009

for operational settings (P01), fault history (P02), real-time clock and pressure schedule

(P11)

0100

for service (P04) and everything else a service technician would need

The general procedures for accessing and changing parameters in the microprocessor are:

1.  Simultaneously press the ‘up’ (+) & ‘down’ (-) keys. The access code screen will appear.
2.  Press ‘enter’ to move forward a digit. Use ‘clear’ (C) to move back a digit.
3.  Use ‘up’ (+) or ‘down’ (-) keys to select the correct number.
4.  Once the correct access code is shown press ‘enter’ to access the menu pages.
5.  Use the ‘up’ (+) and ‘down’ (-) keys to move through the menu pages.
6.  Press ‘enter’ to view the list of corresponding parameters for the selected menu page.
7.  Use the ‘up’ (+) and ‘down’ (-) keys to scroll through the parameters.
8.  Press ‘enter’ to select the parameter to change.
9.  Use the ‘up’ (+) and ‘down’ (-) keys to change the value of the parameter.
10.  Press ‘enter’ to save the new value.
11.  Press ‘clear’ (C) to move back to the previous page, or press and hold ‘reset’ (//) to return to the main

screen.