Sullair LS20T 1100 CFM, Руководство оператора и список запасных частей

Страница: 23 / 146

Section 3
SPECIFICATIONS
17
3.2 LUBRICATION GUIDE-STANDARD COMPRES-
SORS
Refer to Figure 3-1 for fluid fill port location. Sullair
standard compressors are filled with Sullube fluid
as factory fill.
Sullube fluid should be changed every 1200 hours
or once a year, whichever comes first. The fluid
should be changed more frequently under severe
operating conditions, such as high ambient temper-
atures coupled with high humidity, or when high
COMPRESSOR:
Type: 2-Stage Oil Flooded Rotary
Maximum Full Load Operating Pressure: 350 psig (24.1 bar)
Bearing Type: Anti-Friction
Cooling: Pressurized Compressor Fluid
Lubricant: Sullube
Sump Capacity: 50 U.S. Gallons (189.3 Liters)
Control: Supervisor Controller
MOTOR:
Type: O.D.P., 460V, A.C., Three Phase, 60 Cycles
Size: 300, 350, 400, 450, 500, 600HP
Speed: 1800 RPM
Figure 3-1 Fluid Fill Port Location
To be sure that you receive the correct fluid for
your compressor, when ordering fluid, always
confirm your compressor’s fluid fill with the parts
technician by using your compressor’s serial
number.
Mixing of other fluids within the compressor will
void all warranties.
3.1 SPECIFICATIONS- LS20TS
Model Series DIMENSIONS WITHOUT ENCLOSURE (I)
Length Width Height Weight
in mm in mm in mm lb kg
LS20T 800 CFM 157 3988 72 1821 92 2339 (II) (II)
LS20T 960 CFM 157 3988 72 1821 92 2339 (II) (II)
LS20T 1100 CFM 157 3988 72 1821 92 2339 (II) (II)
LS20T 1450 CFM 157 3988 72 1821 92 2339 (II) (II)
(I) Add an additional mm to Height for enclosed models. Add an additional mm to height for air inlet cap.
(II) Add kg for enclosed models.
For noise level information, please contact the Sullair Factory Service Department.
When performing a fluid
change or topping off the
fill, the proper level should
be at half of the sight glass,
with the machine off.
KEY
A FLUID FILL PORT
B SIGHT GLASS
C
SUMP/SEPARATOR
TANK