SUHNER GEM 12, Техническая документация

Страница: 29 / 52

Remove four screws and electrical protection cover (1)
Pull the four control cables through the gland (2).
Connect the cables. Fit protection cover and tighten down
cable gland. Connect to U2, V2, W2 on the controller (see
page 6-7).
2.3.3 c
OntrOl cABle
Connect cable with 3-phase connector with the jack in the
machine. Connect to the controller in accordance with the
terminal connection plan (see page 8-9).
2.3.4 p
Ower supply
The control requires 3x400V (4,7A).
Connection version SK
See page 6-7
Connection version KS Master switch
2.4 r
Ating dAtA
Totoal stroke 60mm (±1%)
Fast forward 0 to 55mm
Working stroke 0 to 60mm
Standard metric thread M2 to M12
Cutting in steel (700N/mm
2
) M2 to M12
Forming in aluminium M2 to M12
Standard inch thread 64 to 13 U/Zoll (r/inch)
Cutting in steel (700N/mm
2
) 64 to 13 U/Zoll (r/inch)
Forming in aluminium 64 to 13 U/Zoll (r/inch)
Tool holder B16 DIN 238 with spring washer
Repetition accuracy ±0.05mm
Motor power 1500/1800min
-1
1.5kW
Power voltage 3x400V
Type of motor protection IP55
Weight without motor 24kg
Weight motor 16.5kg
Paint coating RAL 5012
Control 3x400V (4,7A)
Frequency converter 1.5kW
Impact safety featur Spring / Coupling
Max. feed power approx. 1200N
2.5 O
perAting cOnditiOns
Temperature range during operation: +5 to +50°C
Maximum relative air humidity: 90% at +30°C, 65% at
+50°C
Maximum admissible spindle speed: 5000min
-1
2.6 n
Otes On sAfety during cOmissiOning
Before all work on the machine, it must
first be disconnected from the power sup-
ply.
Only a qualified person familiar with the safety regulations
may start up the machine.
Always conduct test runs without workpieces.
Check the sense of rotation before starting the machine.
The operator must make sure that the components are
integrated and operate safely in the machine.
Only a qualified person may connect the electrical power
supplies in accordance with the local regulations.
The local grounding regulations must be observed and
implemented, and this implementation inspected.
Do not start the machine until the spindle has come to a
stop.
Use only suitable tools, and never modify tools for an ap-
plication they have not been designed for.
After transport, all electrical and mechanical connections
must be examined for damage and loosening, and any
remedial measures taken.
The machine’s working area must be unobstructed and
secured against unauthorized access.
The motor’s and spindle’s sense of rotation may be
checked only when there is no tension in the belt. Correct-
ing a wrong sense of rotation involves swapping over any
29
P
ortugúes
Español
Italiano
English
F
rançais
Deutsch
English