SUHNER MACHINING BEW 12, Техническая документация

Страница: 27 / 48

Air connection inner diameter 4mm
Air consumption per cm stroke 0.15l
Tool hoder: Collet chuck ER25
Sleeve mount DIN 55058 ST28
Running trueness 0.02mm
Maximum input speed 10000min-
1
Type of motor protection IP 55
Weithg 11kg
Paint coating
RAL5012
Flexible shaft connection G28
Required flexible shaft
NA12
2.5 O
perAting cOnditiOns
Temperature range during operation: +20 to +50°C
Maximum relative air humidity: 90% at +30°C, 65% at
+50°C
Compressed air: 5-7bar
Compressed air for pneumatic according to DIN ISO
8573-1 [5/4/4]
Handle tools with caution; keep tools in clean and
sharp condition and observe the tool manufac-
turer’s instructions with regard to the use of cool-
ants and tool holding devices.
Use rotational and advance speeds which are assigned
to the tool and to the material.
2.6 s
AFety instructiOns tO Be OBserVed On
cOmmissiOning
Before all work on the machine, it must
first be disconnected from the power sup-
ply.
Only a qualified person familiar with the safety regulations
may start up the machine.
Always conduct test runs without workpieces.
Check the sense of rotation before starting the machine.
The operator must make sure that the components are
integrated and operate safely in the machine.
Only a qualified person may connect the electrical power
supplies in accordance with the local regulations.
The local grounding regulations must be observed and
implemented, and this implementation inspected.
Do not start the machine until the spindle has come to a
stop.
Use only suitable tools, and never modify tools for an ap-
plication they have not been designed for.
After transport, all electrical and mechanical connections
must be examined for damage and loosening, and any
remedial measures taken.
The machine’s working area must be unobstructed and
secured against unauthorized access.
When internal cooling is used, please observe the instal-
lation instructions issued by the manufacturers of the at-
tachment and rotating union.
The motor’s and spindle’s sense of rotation may be
checked only when there is no tension in the belt. Cor-
recting a wrong sense of rotation involves swapping over
any two of the phase conductors.
The motor cable’s shielding must be connected to the
motor housing over a large area at the terminal board.
3. h
anDling
/o
PEration
3.1 c
OntrOl
The machine is controlled using a corresponding external
drive unit.
3.2 t
OOls
3.2.1 i
nstAllAtiOn OF cOllet chuck
Insert the collet chuck into the clamping nut until the pull-
out knob snaps into the groove of the chuck. Screw the
clamping nut together with the collet chuck onto the drive
spindle. Insert the tool into the chuck and tighten down
the clamping nut to a maximum torque of 32Nm.
Use only special wrenck included in product
package.
ER25 / DIN 6499.
4. s
ErvicE
/m
aintEnancE
4.1 p
reVentiVe mAintenAnce
4.1.1 s
AFety meAsure priOr tO mAintenAnce
Switch off the machine and separate from power
supply.
4.1.2 l
uBricAtiOn chArt
No lubrication required.
4.1.3 c
leAning
Clean fully extended quill periodically.
P
ortugúes
Español
Italiano
English
F
rançais
Deutsch
English
27