SUHNER MACHINING BEA 16, Техническая документация

Страница: 36 / 60

1.1 g
enerAl nOtes On sAfety
This operation manual is applicable for the machine BEA
16.
The machine may only be handled by personnel
who are qualified.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
The machine is suitable for all machining operations need-
ing axial force and torque like drilling, reverse drilling, chip
breakage, countersinking, and reverse countersinking.
The machine is designed for taps conforming to standard
specifications. The machine is specifically ideal for plant
construction, but may also be used as standalone appli-
cation if controlled accordingly.
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclArAtiOn Of incOrpOrAtiOn
The manufacturer Otto Suhner AG of Industriestrasse 10,
CH-5242 Lupfig, hereby declares for the partly completed
machinery (see reverse side for type and serial no.) that
the following fundamental requirements of the Directive
2006/42/EC are applied and fulfilled in accordance with
Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1, 1.5.1,
1.5.4, and 1.6.1. Technical documentation was generated
for the partly completed machinery in accordance with
Annex VII of the Machinery Directive. Document Agent:
I. Sebben. Authorised sites are provided with this techni-
cal documentation in paper or electronic form on justified
request. This partly completed machinery may be put into
operation only when the machine in which the partly com-
pleted machinery is to be incorporated has been ascer-
tained to fulfil the conditions under the Machinery Direc-
tive. CH-Lupfig, 08/2018.
I. Sebben/Division manager
2. c
ommissioning
2.1 A
ssemBly instructiOns
Maximum admissible machine fastening
error.
The machine is fastened at the bores pro-
vided in the housing.
Screws of quality grad 8.8 must be used. The starting tor-
que for the holding down bolt is maximum 25Nm.
1. n
otEs on
s
aFEty
Connect the cables only after the machine has
been completely installed.
2.1.1 f
Astening Of the mAchine On its mOunt
Correct lifting of machine with a crane.
2.2 c
Onnecting the pOwer tO the mAchine
The control must first be wired befor it is
connected to the power supply.
2.2.1 A
synchrOnOus mOtOr
Connect to 41N1, X5 on the control. Connect the shielding
to the earthing module on the control.
36
P
ortugúes
Español
Italiano
English
F
rançais
Deutsch
English