SUG AWI Series, Руководство по эксплуатации товара, Страница: 9 / 12

After setting a preset value (assuming the value is 5N.m), the force applied by the
wrench will gradually increase from Minimum measure value. When force is applied,
the displayed value will change as the user applies different amounts of force; the
reading will increase as force increased, and decrease as force decreased. The reading
will back to preset 5 N.m when the user releases his grip and lets up.
PEAK MODE (P)
After setting a value (assuming the value is 5N.m), the force applied by the wrench will
gradually increase from Minimum measure value. When force is applied, the displayed
value will keeps showing the max torque value when the user applies different amounts
of force; after the user release the grip and let up, the max value will keep on flashing,
it will back to the original setting data when press the P/C key, if you apply force again
and the measured torque value will rise from Minimum measure value again.
∧
(UP) /
∨
(DOWN) SELECTION
Pressing the
∧
(up) key once will cause the value on the far right to increase by one;
pressing the key continuously will cause the value to increase continuously. Pressing
the
∨
(down) key once will cause the value on the far right to decrease by one,
pressing the key continuously will cause the value to decrease continuously.
LED & BUZZER
There will be a beep each time a key is pressed.
In the tracking mode, for example: when the preset torque value is 20N.m, the reading
will begin to increase from Minimum measure value as soon as the user begins to apply
force. When it approaches the 80% of preset value(16N.m), the red LED light will
begin to flash and the buzzer will be on. As the applied torque approaches the preset
value, the red light will flash faster, and the buzzer will buzz faster. When the applied
torque reaches 100% of the preset value(20N.m), the red LED light and buzzer will be
on continuously. The LED and buzzer sound will decrease gradually as force is
released.
The peak mode works the same as the tracking mode.
RESET MEMORY FUNCTION
Press and hold P/C key and
∨
key together until the screen displays "0 to 00000",
and flashes for 3 times, then all values will be back to factory preset datas.
BACKLIGHT SWITCH
Press the P/C key +
∧
(up) key to turn the backlight on or off; the backlight is preset
to be on.
RESET