To finish, use the last four of the M6 screws and the 4 mm hex wrench to attach the screw
clamps to the mount back plate as displayed in the image above. There is an extra threaded
hole in the screw clamps spaced at 50 mm which is not used; just use the 40 mm spaced
threaded holes.
The mount plate has a large variety of holes in it which match a variety of common controllers.
On the next page is a color coded drawing key for each hole pattern. The holes which can be
used by the Sublight 6DOF Joystick are highlighted in green, and orange. There are two sets of
patterns for the Sublight 6DOF Joystick, to allow the controller to be mounted 25 mm forward or
backward. For best results, use the brighter colored green or brighter orange hole patterns, as
this puts the joystick nearer to the user, and allows the handle grip the most motion freedom.
