Subaru Robin Engines SX17, Инструкция по эксплуатации

Страница: 13 / 22

5
ENGLISH
FRANÇAISE
ESPAÑOL
3. PRE-OPERATION CHECKS
4. ELECTRIC STARTER MODELS
NOTE
Engine shipped from our factory is without oil.
Before starting engine, fill with oil. Do not over-fill.
1. CHECK ENGINE OIL (See Fig.
2
)
Before checking or refilling engine oil, be sure the engine is
located on stable, level surface and stopped.
■ Do not screw the oil gauge into the oil filler neck to check oil
level. If the oil level is low, refill to the upper level with the
following recommended oil.
■
Use 4-stroke automotive detergent oil of API service class
SE or higher grade.
■
Select the viscosity based on the air temperature at the
time of operation as shown in the table. (See Fig.
2 - ① )
CAUTION
Air cooled engines run hotter than automotive
engines.
The use of non-synthetic multi-viscosity oils
(5W-30, 10W-30, etc.) in temperatures above
40°F(4°C) will result in higher then normal oil
consumption. When using a multi-viscosity oil,
check oil level more frequently.
Oil capacity (Upper level) : Oz (L)
SX17/21 . . . . . . . . . . . . . . . . . . . .20.3 (0.6)
SX30 . . . . . . . . . . . . . . . . . . . . . .33.8 (1.0)
2. CHECK FUEL (See Fig.
3
)
WARNING
Do not refuel while smoking, near an open flame
or other such potential fire hazards. Otherwise
fire accident may occur.
NOTE
THIS ENGINE IS CERTIFIED TO OPERATE ON
AUTOMOTIVE UNLEADED GASOLINE.
Fuel tank capacity : Qts (L)
SX17 . . . . . . . . . . . . . . . . . . . . . . .3.6 (3.4)
SX21 . . . . . . . . . . . . . . . . . . . . . . .3.8 (3.6)
SX30 . . . . . . . . . . . . . . . . . . . . . . .6.4 (6.1)
■
Stop the engine and open the cap.
■ Close the fuel valve before filling the fuel tank.
■ Do not fill above the top of the fuel filter screen
(marked ❶ ), or the fuel may overflow when it heats up later
and expands.
For electric starter operation, proper electric wiring
arrangements are needed before normal engine operation.
WIRING DIAGRAM
(SX17,21)
Spark plug
Black
Black
Black
Stop switch (Safety Key)
Ignition coil
Flywheel
Stop switch
(Speed Conrol Lever)
Electric starter
AC120V
Push switch
(Push Button Electric Start)
AC120V
(SX30)
Spark plug
Black
Lamp
Lamp coil
Magneto
Ignition coil
Black
Blue
Light Blue
Black
Stop switch (Safety Key)
Stop switch
(Speed Conrol Lever
)
Electric starter
AC120V
Push switch
(Push Button Electric Start)
AC120V
Optional hardware shown by dotted lines.
■ When filling the fuel tank, always use the fuel filter screen.
■
After refueling, tighten the fuel cap (rotate clockwise) until
it makes a physical stop, there will be a relief in resistance
just before the physical stop.
This will form a vapor seal between the tank and fuel cap.
■
Wipe off any spilled fuel before starting the engine.