5
（5） Attaching the air outlet garnish
Revised contents
△
Details of the work
date
Newly created document
2021.04.02
00
Caution
The installation work is complete when the air
outlet garnish is attached by applying pressure
(approx. 5 kgf) and securely fixed to the car body.
Ensure that there is no peeling in the attached
area or no adhesive joint failure, including
separation. [Figure 6]
Avoid getting the car wet by washing it, etc.
within 24 hours after the work is complete.
Otherwise, it may cause the adhesive to peel.
After completing the pressure bonding, remove
the installation support from the car.
When the surface is soiled after the completion
of the work, wipe the surface clean with a
waste cloth.
Do the same for the right side.
（6）Pressure bonding and completion check
Insert the V-shaped part of the air outlet
garnish while aligning it with the projection of
the liner design. Check also the alignment of
the convex part and then attach Ⓐ with the
double-sided tape.
Temporarily attach Ⓑ and Ⓒ with the
double-sided tape while aligning the bottom
edge with the top edge of the paper pattern.
[Figure 5]
【Figure 6】
【Figure 5】
Make sure not to misalign the garnish with
or allow it to protrude from the paper
pattern.
Caution
2
1
Ⓑ
©
Ⓐ
Avoid double-sided tape Ⓐ from
touching the liner.
Avoid holding this product only by their
ends to prevent it from being twisted or
bent.
Removing this product from the liner after
temporarily attaching it with the
double-sided tape may cause wrinkles,
breaks, or cracks on its coating surface.
NG
NG
Inspection Methods
Please confirm that there is not the
gap and runover with the paper
pattern.
In the illustration range, please
confirm that there is not a gap.
Pressure
bonding
Pressure
bonding