JP
GB
FR
DE
NL
ES
IT
PT
GR
NO
SE
FI
DK
RU
8
AR
US
1. FUNCTION OF OIL SENSOR
The engine will stop automatically when the oil
level falls below the safety limit. The engine
cannot be started unless the level is raised
above the prescribed limit. (See Fig.
2
-
w
)
2. RESTARTING
(1) Fill the crankcase with oil up to the proper
level.
(2) As for restarting and operating the engine,
refer to section "
4. OPERATING YOUR
ENGINE
" on page 5 .
■
■
Check the wire connector from the engine.
It must be connected securely to the wire
from oil sensor.
■
■
When selecting the engine oil, refer to page 5
for the recommended oil.
8. EASY TROUBLESHOOTING
7. OIL SENSOR INSTRUCTIONS
(OPTIONAL)
WHEN ENGINE WILL NOT START :
Perform the following checks before you take the
engine to your Robin dealer. If you still have
trouble after completing the checks, take the
engine to your nearest Robin dealer.
1. Is there a strong spark across the
electrode ?
(1) Is the stop switch at position "
" (ON)?
(2) Remove and inspect the spark plug.
If the electrode is fouled, clean or replace it
with new one.
(3) Remove the spark plug and connect it to the
plug cap.
Pull the starter handle while grounding spark
plug against engine body. Try with a new spark
plug if the spark is weak or there is no spark.
The ignition system is faulty if there is no
spark with a new spark plug.
2. Is there enough compression?
Pull the starter handle slowly and check if
resistance is felt. If little force is required to pull the
starter handle, check if the spark plug is tightened
firmly. If the spark plug is loose, tighten it.
3. Is the spark plug wet with gasoline?
(1) Is the fuel cock opened?
(2) Choke (close choke lever) and pull the starter
handle five or six times. Remove the plug and
check if its electrode is wet. If the electrode is
wet, fuel is well supplied to your engine.
(3) When the electrode is dry, check where the fuel
stops. (Check the fuel intake of the carburetor.)
(4) In case the engine does not start with well
supplied fuel, try using fresh fuel.
NOTE
The engine with oil sensor will stop automatically
when the oil level falls below the prescribed limit.
Unless the oil level is raised above the prescribed
limit, the engine will stop immediately after starting.
■
■
Wipe out spilled fuel carefully before
testing. Place spark plug as far away
from spark plug hole as possible.
■
■
Do not hold spark plug by hand while
pulling recoil starter.
WARNING
EH092_GB_EU2311 06.12.21 1:38 PM ページ8
Содержание DY23
Страница 1: ...7 6 2 8 2 2 2 2 2 2...
Страница 12: ...EH092_GB_EU2311 06 12 21 1 38 PM 10...
