23
24
Panel Cutout & Dimensions
Note : All dimension are in mm.
59
92
92
45
Top View
Side Lock
CONTROLLER
PANEL
106.2
50
Front View
Max
15 mm
59
50
45
WIRING :
The probe and its corresponding wires should never be installed
in a conduit next to control or power supply lines. The electrical wiring
should be done as shown in the diagram. The power supply circuit should
be connected to a protection switch. The terminals admit wires of upto
2.5sq mm.
WARNING :
Improper wiring may cause irreparable damage and personal
injury. Kindly ensure that wiring is done by qualified personnel only.
Maintenance :
Cleaning : Clean the surface of the controller with a soft
moist cloth. Do not use abrasive detergents, petrol, alcohol or solvents.
Fixing and dimensions of panel models :To fix the unit, slide the side lock
1
through the guides
2
as per the position shown in the figure. Move the side
lock in the direction of the arrow, it permits to move the fastener in the opposite
direction of the arrow.
3
Fit the screw in the side lock in direction of the arrow to
hold the controller in the panel.
Installation
Controller
Controller should be installed in a place protected by vibration, water and
corrosive gasses and where ambient temperature does not exceed the values
specified in the technical data.
Probe
To give a correct reading, the probe must be installed in a place protected from
thermal influences, which may affect the temperature to be controlled.
CAUTION
NC-120A
NC-120A
