Sheet# 971826
Revision C (1/17)
Stylmark, Incorporated
♦
6536 Main Street NE, PO Box 32008
♦
Minneapolis, MN 55432
1-800-328-2495
♦
www.stylmark.com
Stylmark Installation Instructions: Admire LED Mirror
Step-by-Step Instructions – Wings
1.
With Admire Mirror pre-installed, measure down from
the top surface of the Admire Mirror making one
small pencil location mark at 12-7/8”. Then measure
up from the bottom edge and make a mark at 11-
29/32”. Using a carpenter’s square, draw a
perpendicular line from the side of the Admire Mirror
at each of the pencil location marks. Note: the
perpendicular line will be used for lining up the top
edge of the wall mount brackets. See Figure 13
2.
Locate the top edge of the wall mount bracket flush
with the perpendicular lines and flush to the side of
the Admire Mirror. Once located, fasten each wall
mount bracket through the slotted mounting holes
using fasteners with a minimum pullout rating of
75lbs per fastener (obtain locally).
See Figure 13
3.
With the wall mount brackets securely fastened in
place, carefully lift and lower the mirror wing onto the
wall mount brackets making sure it is flush with the
four wall mount bracket tabs and in line with the four
frame brackets. See Figure 14
4.
Once the mirror wings are in place on the wall mount
bracket, to minimize the gap between the mirror and
the wing and to secure the wing in place, gently push
the wing frame edge towards the pre-installed Admire
Mirror. With slight pressure applied to the wing
frame edge, fasten the set screws through the frame
bracket and into the wall mount bracket tabs.
See Figure 15
Figure 15
Figure 14
