Sheet# 971826
Revision C (1/17)
Stylmark, Incorporated
♦
6536 Main Street NE, PO Box 32008
♦
Minneapolis, MN 55432
1-800-328-2495
♦
www.stylmark.com
Stylmark Installation Instructions: Admire LED Mirror
Getting Started:
Please review the important safety instructions
before starting. Installation should be performed by
authorized personnel only. This mirror is for
commercial use only, intended as a viewing mirror.
Step-by-Step Instructions – With Hardwired
Connection:
1.
Remove the product from the box and put the mirror
and setting blocks aside.
2.
Determine mounting location. Location must have
power source location on the wall within the inner
area of the fixture. The fixture includes slotted
mounting holes located in the top and bottom of the
fixture. The distance from floor is to be determined
by customer. Stylmark recommends this distance to
be a minimum of 8”. See Figure 2
3.
Fasten mirror frame to wall studs or suitable
structural location through slotted mounting holes in
both the top and bottom of the frame. Use fastening
screws with a minimum pullout rating of 75lbs per
fastener (obtain locally).
Note: Fixture must be level & plumb.
4.
Once metal frame is securely attached to wall,
remove the power enclosure cover and connect all
wiring per applicable local codes. See Figure 3
When finished, replace the power enclosure cover.
5.
Position the setting blocks on the lower edge of the
frame. See Figure 4
6.
Using vacuum glass cups, install the mirror by lifting
it up into the top channel, then down into the lower
channel and onto the setting blocks. See Figure 5
Figure 3
Figure 4
