10
Lowes.com
POWER
The power switch supplies power to all of the functions of the
fi
replace.
HEATER
The
fi
replace consists of a fan-forced wire-element-type heater. The heater switch turns the heater
ON and OFF. As an important safety feature, the heating element is designed with a
delayed activation sequence. When the heater is turned ON it will take several seconds for the unit
to begin blowing hot air and the fan blower will continue to run for several seconds after the heater is
switched OFF.
TEMPERATURE
The temperature control knob regulates the temperature level of the heater. Turning the knob
clockwise will increase the heat output. The further the knob is rotated clockwise, the higher the
set point temperature. Turning the knob counterclockwise will lower the set point temperature.
Use this function to help regulate the ambient temperature level.
BRIGHTNESS
The
fl
ame brightness control knob adjusts the
fl
ame brightness. Turning the knob to the left
(counterclockwise) dims the lights and
fl
ame effect. Turning the knob to the right brightens the lights
and
fl
ame effect.
CARE AND MAINTENANCE
CLEANING TRIM
Clean the metal trim using a soft cloth, slightly dampened with a citrus oil-based product and buff with a
clean soft cloth. Do not use brass polish or household cleaners as these products will damage the metal
trim. Citrus oil-based products can be obtained at supermarkets or hardware stores.
REPLACING THE LIGHT BULBS
This electric
fi
replace uses two clear 120-volt, 40-watt, E12 candelabra-base light bulbs.
For convenience, if a bulb burns out, it is a good idea to replace all the bulbs at the same time.
Refer to the steps below.
• Dust your
fi
replace regularly with a soft non-lint producing cloth or household dusting product.
• Clean your
fi
replace with a gentle non-abrasive household cleaner. Make sure to dry your
fi
replace
immediately with a soft cloth or towel.
• Tips for using touch-up pen (DD): For scratches, stroke in direction of scratch. For worn areas,
stroke in direction of wood grain. Rub excess colorant promptly with a soft cloth.
• The motors used on the fan and the
fl
ame generator assembly are pre-lubricated for extended
bearing life and require no further lubrication. However, we recommend periodic cleaning/vacuuming
of the fan/heater.
• Make sure the unit is turned off and unplugged whenever you are cleaning the heater or
fi
replace.
