3
ASSEMBLY INSTRUCTIONS
1. Align and lower the top with tubing (B) onto the
fountain (A). Position the top with tubing (B) so the
water flow will spill into the middle of the next bowl
when operational.
2. Using the access hole located at the rear of the
fountain (A), locate the tubing. Attach the tubing to the
pump (C). Place pump (C) inside the fountain body
reservoir.
3. Using the access hole located at the rear of the
fountain (A), locate the 2 to 1 connector (E) and drape
it out the rear of the fountain (A). The 2 to 1 connector
(E) should not be submerged. Connect the cord from
the 2 to 1 connector (E) to the transformer (F).
4. To prevent the risk of water loss during operation,
create a drip loop with the light cords as shown. Fill
the water reservoir with enough water to completely
submerge pump (C). Install the pump access door (G).
5. Connect the power cords into an electrical socket to
run the fountain.
1
2
3
4
5
A
B
C
A
A
C
G
E
F
