STX Mega-Steam 4000 SX2, Инструкция по эксплуатации

Страница: 15 / 20

- 13 -
5. Select and attach the desired accessory (See previous section).
6.
Plug the steam cleaner into an electrical outlet. Set the ON/
OFF button to ON. The red LED will light up at this time. It takes
approximately 10 minutes for the steam cleaner to produce super-
heated steam. The green LED will light up when the unit is ready to
operate.
7. Squeeze the trigger on the steam gun to check steam production and
begin steam cleaning.
8. Monitor the steam production and water level. The green LED will turn
off when the steam reservoir is depleted. If there is still plenty of water
in the tank, release the steam gun trigger and wait 8-10 seconds for
the steam reservoir to replenish. The green LED will light up again
and you can continue steaming.
NOTES:
• Adjust the steam flow intensity know counter-clockwise to
get desired steam intensity.
• The length of time for continuous steam will vary based on
how high the steam flow control knob is set. The higher
it is set, the more often you will need to allow the unit to
replenish the steam resevoir.
• For the first 3-5 seconds when you start the steam flow a
small amount of water may be released. Water condensation
occurs in the tank, flexible hose, and any attachments being
used. This will quickly be replaced by 98% steam.
• The child lock yellow button on the steam gun will prevent
the trigger from functioning when it is pressed.
TIPS
:
• For best results, move the steam gun/accessory back and forth
on the object being steamed rather than directing the steam at
any one point for long periods of time.
• The flow rate of steam can be regulated with the steam flow
control knob on the base of the steam cleaner.