Powerhouse 300
3
The voltage selector (the square shaped part which can be levered out) contains the AC fuse.
This is the voltage selection procedure. Check that the pointer (see diagram above) is pointing at the local AC
supply voltage (100, 120, 220 and 240V are stamped on the voltage selector). If it is, then go ahead and connect AC
power to the console.
If the voltage indicated is wrong, then lever out the voltage selector (there is a small notch for this purpose between
the selector and the AC power input). Turn the selector round until the pointer is pointing to the correct voltage, then
press it back in.
You will have noticed a fuse while the selector was out. This is the console's AC fuse. It is a 20x5mm T2A 250V in
all units. The console is now ready to have the power lead connected and be switched on.
1:3 IMPORTANT! COOLING INFORMATION
There is a cooling vent in the base of the POWERHOUSE consoles. This MUST NOT be obstructed in any
circumstance, as overheating of the unit will occur.
If the POWERHOUSE is transported in a flightcase, it should be lifted completely from the flightcase before use.
1:4 IMPORTANT! TO PROTECT YOUR LOUDSPEAKERS
Always turn the TO AMP control to 0 before turning the console on or off.
Содержание Powerhouse 300
Страница 1: ......
