MIC
LINE
INSERT
DIRECT
OUT
11
MIC
LINE
INSERT
DIRECT
OUT
12
MIC
LEFT/ MONO
LINE
RIGHT
13
MIC
LEFT/ MONO
LINE
RIGHT
14
EXPECT THE BEST
www.studiomaster.com
EXPECT THE BEST
www.studiomaster.com
EXPECT THE BEST
www.studiomaster.com
EXPECT THE BEST
www.studiomaster.com
WHAT HAPPENS IF I PRESS THIS?
CONTROLS & FEATURES
6
EXPECT THE BEST
www.studiomaster.com
www.studiomaster.com
Controls & Features - Rear Panel Input Section
45
MIC
: MIC 3 pin XLR input - For balanced, low impedance
microphones.
48V phantom power may be applied globally to all Mic inputs by
depressing the recessed 48V switch on the rear panel using a
plastic ball-point pen or similar object. A status LED on the front
panel confirms that the phantom power is operational.
Do not use +48V phantom power with unbalanced mics
connected to the console.
If any channels require the +48V to be disconnected see
options
section.
46
LINE Channels 1 - 12
: LINE 1/4" TRS jack input for use with
balanced, line level signals.
The line input is electronically balanced but may also be used
with unbalanced sources by simply plugging in an unbalanced
jack (TS) lead.
High impedance sources such as electric guitars should be fed
in via a DI box or suitable preamplifier for best results.
47
LINE (LEFT/MONO & RIGHT) Channels 13 - 16
: Line 1/4"
TRS jack for the connection of stereo line-level devices (drum
machines, keyboards, effect processors, etc). For mono
operation plug into the LEFT/MONO jack only.
The line input is electronically balanced by may also be used
with unbalanced sources by simply plugging in an unbalanced
jack (TS) lead.
48
INSERT
: In effect a send/return for the channel on a single
1/4" TRS (tip, ring, sleeve) jack.
Use a 'Y' - cable to connect the tip to the input and the ring to
the output of an inline device (compressor, equaliser, etc).
49
DIRECT OUT
: An output taken from the channel to be routed
elsewhere - multitrack recorder, monitor mixer, etc. The signal
is post - EQ and post - fader, so signal from the direct out is
exactly the same as that sent to the main outputs. (To change
the signal source see Options Section)
50
VOLTAGE SELECTOR
: Do not adjust this switch when the
A.C. power cord / mains lead is connected. For supplies
between 220 and 240V use the 230V position. For supplies
between 110 and 120V use the 115V position.
51
POWER CONNECTOR
: The A.C. power connector also
contains the internal A.C. power fuse.
45
47
46
48
49
45
230
51
50
EXPECT THE BEST
www.studiomaster.com
EXPECT THE BEST
www.studiomaster.com
EXPECT THE BEST
www.studiomaster.com
EXPECT THE BEST
www.studiomaster.com
