For BRIDGE mode operation, the signal source should be connected to the balanced /unbalanced inputs of channel 1 only. This
mode combines power output of both channels for connecting a single loudspeaker load. The combined loudspeaker load should
not go to below 4 ohm.
Connect the line output of a mixer to a channel A input of
the amplifier. Input can be wired as per fig.1 & 2 (Input
Connections for Balanced and Unbalanced Mode) as
mentioned in wiring information on page no. 6.
Connect a speaker system (8 ohm / 4 ohm) on the
speakon output of channel 1 only. It is recommended
to use the speakon connectors and wire these as per
fig.4 (Output Connections for Bridge Mode) as
mentioned in wiring information on page no. 6.
To select BRIDGE mode, keep the slide switch, provided at
rear panel, in Bridge position.
The desired output levels of both the channels are adjustable
by volume control of channel 1 only.
The level indicator LEDs glow to indicate the presence of
signal at the output terminals.
9
GND
LOW
CUT
OFF
SUB
LOW
CUT
OFF
SUB
120
63
140
43
180
SENSITIVITY
0.775V
1.2V
MONO
STEREO
BRIDGE
FREQUENCY (Hz)
BASS/BOOST
OFF
ON
LIMITER
OFF
ON
FREQUENCY (Hz)
120
63
140
43
180
BRIDGE
For MONO or BRIDGE MODE use Input CHA.
CHANNEL B
Output Connections
ST & MO Mode
+1 = s
-1 = speaker -
BR Mode CH A only
+1 = s
+2 = speaker -
CHANNEL A
WARRANTY VOIDS IF
SERIAL NO. IS MISSING
MADE IN INDIA
INPUT
OUTPUT
C
H
A
N
N
E
L
B
C
H
A
N
N
E
L
A
16A
240V~/50Hz
30A, 6300W
XPA 40
IS 616/IEC 60065
R - 71003344
MCB
PUSH TO RESET
Bridge: Mode Configuration
MONO
BRIDGE
STEREO
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
AQ
UA 10
