7
In STEREO mode, both channels A & B are fully independent of each other. The balanced /unbalanced inputs can be connected
either to a stereo signal source or two independent mono signal sources. Each channel can separately drive loudspeaker loads of
8 ohm or 4 ohm or 2 ohm.
Connect the Left & Right outputs of a mixer to channel A
& B inputs of the amplifier respectively. Inputs can be
wired as per fig.1 & 2 (Input Connections for Balanced &
Unbalanced Mode) as mentioned in wiring information on
page no. 6.
Connect a speaker system (8 ohm / 4 ohm / 2 ohm) on the
output terminal of each channel. It is recommended to use
the speakon connectors and wire these as per fig.3 (Output
Connections for Stereo / Mono Mode) as mentioned in
wiring information on page no. 6.
To select STEREO mode, keep the slide switch,
provided at rear panel, in STEREO position.
Adjust the individual volume controls of each channel
on the front panel to obtain the desired output level.
The level indicator LEDs glow to indicate the presence
of signal at the output terminals.
GND
LOW
CUT
OFF
SUB
LOW
CUT
OFF
SUB
120
63
140
43
180
SENSITIVITY
0.775V
1.2V
MONO
STEREO
BRIDGE
FREQUENCY (Hz)
BASS/BOOST
OFF
ON
LIMITER
OFF
ON
FREQUENCY (Hz)
120
63
140
43
180
BRIDGE
For MONO or BRIDGE MODE use Input CHA.
CHANNEL B
Output Connections
ST & MO Mode
+1 = s
-1 = speaker -
BR Mode CH A only
+1 = s
+2 = speaker -
CHANNEL A
WARRANTY VOIDS IF
SERIAL NO. IS MISSING
MADE IN INDIA
INPUT
OUTPUT
C
H
A
N
N
E
L
B
C
H
A
N
N
E
L
A
16A
240V~/50Hz
30A, 6300W
XPA 40
IS 616/IEC 60065
R - 71003344
MCB
PUSH TO RESET
MONO
BRIDGE
STEREO
Stereo Mode Configuration
6. System Application.
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
AQ
UA 10
