I n s t r u c t i o n m a n u a l
VMK SERIES
sliders/knobs
PROCEDURE: SLIDER / KNOB PROGRAMMING
We will set up a
SLIDER
to behave like an analog mixer fader. Fader Down>min. volume. Fader Up>Max. Vol.
Programing
KNOBS
follows the
Exact
same procedure.
TIP:
Unlike an analog mixer you might not want your minimum volume to be 0 (no sound). You may just want a track to “sit” in
the mix. Therefore you should choose a value greater than 0. For example, you may want to “ride” a guitar part and not want its
volume to dip below a certain level in the mix. In that case set the
Min.
to a value that sounds good. Then when you pull the fader
down you’ll still hear the guitar without having to worry about fader position. You can reverse this example for
Max
Values also.
1) PRESS EDIT
2) MOVE SLIDER (KNOB)
In this example Move
SLIDER 1
w/
Bank A
Selected
(Remember: keep track of
your BANKS when programing!)
3) PRESS PAGE UP
In this example we’ll use
CTRL Change
number 10.
You may adjust this to any
CTRL number you desire.
4) PRESS PAGE UP
Set the Value Min. to 0
5) PRESS PAGE UP
Set the
Value Max
to 127
In this example when the Slider
is pushed UP it will increase to
the Maximum allowed
PRESS OR MOVE
ANY CONTROLS
SCREEN
CHANGE
EDIT SLIDER
51
MIDI CHANNEL
OFF
SCREEN
CHANGE
To adjust the
Midi Channel
use the
DE
knob
EDIT SLIDER:
51
CTRL CHANGE:
10
SCREEN
CHANGE
To adjust the
CTRL Change
use the
DE
knob
EDIT SLIDER:
51
VALUE MIN.:
0
SCREEN
CHANGE
To adjust the
Value Min.
use the
DE
knob
EDIT SLIDER:
51
VALUE MAX:
127
SCREEN
CHANGE
To adjust the
Value Max
use the
DE
knob
Move SLIDER (1)
17
